HID FARGO HDP8500 User Guide - Manual (Page 164)

© 2012 HID Global Corporation. All rights reserved.
164
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Nos.88 and 89) Printhead voltage. technical assistance.
Headlift Error
(PC Error Message
Nos. 102, 103, 104,
and 105, 291, 292,
293, 294)
This is a problem with the
Printhead Lift or Transfer
Roller Headlift. Remove ribbon and film cartridges.
Check for any obstructions in the
printhead area or mechanism.
Remove any obstructions. Cycle
printhead up and down from the
display. If printhead cycles normally,
reinstall cartridges.
Heater Error
(PC Error Message
No. 161,)
The Transfer Heater Roller is
too hot. Heater or RTD is malfunctioning.
Check heater and RTD connections.
If this problem persists, call for
technical assistance.
Output Hopper Full
(PC Error Message
No. 313)
Output Card Hopper is full to
capacity Empty the Hopper.
Invalid Ribbon
(PC Error Message
No. 94, 95, 96)
An unauthorized Ribbon is
installed in the Printer.
The wrong Securemark
ribbon was installed in the
printer.
Get the correct Ribbon from your
dealer.
Invalid Film
(PC Error Message
Nos. 164, 165, and
166,)
An unauthorized film is
installed in the Printer. Get the correct Film from your dealer.
Internal Laminator
Error
PC Error Message
Nos. 257, 258)
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Job Data Error
(PC Error Message
No. 106)
The print data sent to the
Printer is corrupt or has been
interrupted. Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Lam Check Card
(PC Error Message
Nos. 213 )
A jam occurred inside the
laminator Remove Card from Card Path. Make
sure there are no obstructions to the
Sensor, and recalibrate the Sensor.
Lam Async Error The Printer timed out waiting
for communication from the Check Lam power/connections and