HID FARGO HDP8500 User Guide User Manual
Page 180
© 2012 HID Global Corporation. All rights reserved.
180
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Sensor Error
Film.
properly and press Resume.
To cancel, press the Cancel Print
button or the Cancel button located
on the Printer.
Remove Laminator
Film
To continue, remove the
laminator's film.
Open the Laminator's Front Cover.
Remove the film and close the
Laminator's Front Cover.
Print Film Out
The Print Film installed in
the printer is empty.
Install new Film and press the
Resume button to continue printing.
To cancel the print, press the
Cancel Print button or the Cancel
button located on the Printer.
Print Film is not
Installed
No Print Film is installed in
the Printer.
Install the Film and press Resume.
To cancel the print, press the
Cancel Print button or the Cancel
button located on the Printer.
Print Film Sensor
Error
The Printer cannot find
the next panel on the Print
Film.
Check that the Print Film is installed
properly and press Resume.
To cancel the print, press the
Cancel Print button or the Cancel
button located on the Printer.
Wrong Print Film
Installed
An incorrect Print Film has
been installed, or a driver
setting is incorrect.
Ensure that the appropriate Print
Film is installed and press the
Resume button located on the
Printer to continue printing.
To cancel, press the Cancel Print
button or the Cancel button located
on the Printer.
Print Film Error
The Print Film caused a
general error.
Ensure that the appropriate Print
Film is installed and press the
Resume button located on the
Printer to continue printing. To
cancel, press the Cancel Print
button or the Cancel button.
Invalid Film
An unauthorized film is
installed in the Printer.
Get the correct Film from your
dealer.
Hopper Full
Output Card Hopper is full
to capacity
Empty the Hopper.