HID FARGO HDP8500 User Guide - Manual (Page 136)

© 2012 HID Global Corporation. All rights reserved.
136
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Using the EAT Disable Option
This is and ON or OFF switch. 0 is off and 1 is on. This will tell the printer to keep track of the
environmental temperature and compensate for it.
“Environmentally Adaptive Transfer” automatically adjusts the transfer temp based on the
ambient air conditions within the printer. Will increase or decrease the transfer roller temp by as
much as 20C in extreme conditions.
This mode defaults to on and a setting of “1” will disable.
Using the Enable Ribbon Wrinkle Compensation Option
This is an on or off switch. When this enabled it will turn on extra pixels on the printhead to help
with ribbon wrinkle during the print process.
Using the Standby Time Option
This option changes the time used when the printer enters standby mode.
Using the BEEP disable Option
This setting will disable the beep the printer generates after an EE settings gets updated.
Using the I Panel Heat Offset Option
This option adjusts the heat used during the removal of unwanted HDP Film. Use minimal
adjustments, or print ribbon and HDP Film breaks may occur.
Using the Holo Transfer Offset Option
This option changes the Hologram Overlamiate Offset for placement parameters.
Using the Standby Temp Option
This option changes the temperature used when the printer is in standby mode.