HID FARGO HDP8500 User Guide - Manual (Page 70)

© 2012 HID Global Corporation. All rights reserved.
70
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Adjusting the Film Type
Step Procedure
1 Allows you to select the film type option that is appropriate for the type of
HDP film currently loaded in the Printer.
Select the Clear option to automatically adjust the appropriate transfer
time and temperature to pre-determined defaults. (Note: Select this
option to automatically adjust the transfer temperature and the dwell
times to defaults when non-custom card type is chosen on Card tab.)
OR
Select the Holographic option to change appropriate internal Printer
settings needed to make the holographic film work. (Note: Select this
option to automatically adjust the transfer temperature and the dwell
times to defaults when non-custom card type is chosen on Card tab.)
(Note: It will also adjust the necessary transfer temperature and the
dwell settings in the Driver to provide the optimal holographic InTM
performance.)
Using the Dual Sided Group Functions
The Dual Sided group checkboxes (shown below) are grayed out if no Flipper is automatically
found or if the Dual Sided is manually turned off. See the procedures in this section for more
instructions.