HID FARGO HDP8500 User Guide - Manual (Page 162)

© 2012 HID Global Corporation. All rights reserved.
162
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
No. 69) Load cards into Hopper.
Check Film
(PC Error Message
No. 244)
The film is not able to move
correctly.
The film has become
jammed or the wrong
number of film marks was
seen during printing.
Check for jams/breaks.
Verify film is installed correctly in
cartridge.
Remove film and check for any
damage to the film. Scroll film to
unused panel, install film cartridge
and cancel last print job.
Check Laminate 1
(PC Error Message
Nos. 231)
The Laminator was unable to
find the mark on the material
in cartridge one. Make sure there are no obstructions
to the Sensor, and recalibrate the
Laminator Sensor.
Check Laminate 2
(PC Error Message
No. 232)
The Laminator was unable to
find the mark on the material
in Cartridge 2. Make sure there are no obstructions
to the Sensor, and recalibrate the
Laminator Sensor.
Check Film Error
(PC Error Message
Nos. 26, 158, and
176, 290)
The film is not able to move
correctly. Check for
jams/breaks. Check for obstruction.
Verify film is installed correctly in
cartridge.
If the problem persists, call for
technical assistance.
Check Ribbon
(PC Error Message
No. 97, 98, 99)
The Ribbon is not able to
find the next panel correctly.
Check for jams/breaks. If jammed, clear the jam. If broken,
repair by taping the Ribbon back on to
the take-up core.
Press Resume to continue or Cancel
to abort.
Cover is Open
(PC Error Message
No. 295)
Cover is open and printer
going into pause mode. Close printer cover and resume.
Expansion Board
Error
(PC Error Message
No. , 315, 316)
An error has occurred on
one of the expansion boards;
Comm Error, ASYNC
Timeout, Timeout Reset the Printer and try again.
If this problem persists, call for
technical assistance.
EEPROM Error
(PC Error Message
No. 38,39,40,44,52)
Reset the Printer and try again.
If this problem persists, call for
technical assistance.