HID FARGO HDP8500 User Guide - Manual (Page 168)

© 2012 HID Global Corporation. All rights reserved.
168
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
(PC Error Message
No. 201, 211) sided Printer.
No flipper module is installed
in the printer.
The laminate is in the wrong
position for the side they
want to laminate, and they
don't have a flipper.
capabilities via the LCD Menu.
If Flipper capabilities are present,
ensure that the Print Both Sides
option in the Driver is set correctly.
Press the Resume button on the
Printer‟s Front Cover to continue
printing.
To cancel the print, press the Cancel
Print
button from the Driver‟s display
dialog.
No Mag Module
(PC Error Message
No. 31)
MAG encoding job sent to
Printer without a MAG
Encoder.
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type.
No Ribbon
(PC Error Message
No. 25, 100)
No Ribbon is installed in the
Printer.
OR
The Ribbon RFID tag is bad. Install the correct Ribbon and press
the Resume button located o the
Printer‟s LCD display.
To cancel the print, press the Cancel
Print button from the Driver
‟s display
dialog and the Cancel button located
on the Printer
‟s LCD display.
Printing Error
(PC Error Message
No. 107)
An error was detected during
printing. Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Printhead thermistor
error
(PC Error Message
No. 8)
The Printhead Temperature
Sensor is not functioning or
is not connected properly.
OR
The Printhead is not cooling
properly. If the problem persists, call for
technical assistance.
Printhead Temp Error
(PC Error Message
Nos. 9,67)
Unspecified system error
detected by the Printer
Firmware. Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Remove Card
(PC Error Message
No. 68)
A card is jammed in the Print
Station or card flipping area
of the Printer. Clear the jam and press Cancel.