HID FARGO HDP8500 User Guide - Manual (Page 139)

© 2012 HID Global Corporation. All rights reserved.
139
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Warming Time Delay
The setting adjusts how much additional time (in minutes) the printer will wait after the
transfer roller reaches temperature before beginning transfer. It has a range of 0 to 20.
Power On Ribbon Film Skip
This setting enables power up ribbon/film savings. When enabled the ribbon and film will
not skip to a new set of panels after a power up. Cover open/close behavior is unaffected, so
upon a cover close the ribbon and film will skip a set of panels.. 0
– disabled/1- enabled.
Flipper Reject Angle
This setting adjusts the flipper angle when trying to place a card in the reject hopper. It has a
range of +/-20. This setting should not be needed.
Input Hopper Home Offset
This setting adjusts the position of the shuttle when it‟s in the home position. It has a
range of 0 to 30. The larger then number the closer to the front of the printer the shuttle will be
placed. The printer must be rebooted for this setting to take effect.
Input Hopper Mag Offset
This setting adjusts the position of the shuttle when it‟s in the mag position. It has a
range of -20 to 20. The larger then number the closer to the front of the printer the shuttle will be
placed. The printer must be rebooted for this setting to take effect.
Transfer Image Length
This setting adjusts the length of the image on the card during transfer. It has a range of
-10 to +10. The larger the number, the longer the image.
Transfer Cooling Delay
This setting adjusts the delay (in seconds) before transferring the second side of the
card. It has a range of 0 to 180. The larger the number, the longer the delay in seconds..