HID FARGO HDP8500 User Guide - Manual (Page 137)

© 2012 HID Global Corporation. All rights reserved.
137
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Using the Mag Hi-Co Voltage Offset Option
This option changes the voltage going the magnetic head.
This is factory set and should not be changed unless directed by a technician.
Using the Mag Lo-Co Voltage Offset Option
This option changes the voltage going the magnetic head.
This is factory set and should not be changed unless directed by a technician.
Using the Mag Flipper Angle Offset Option
This option changes the angle of the Flipper Table. Increasing the flipper angle will rotate the
flipper table clockwise. This is factory set and should not be changed unless directed by a
technician.
Using the Fluorescent (F) Panel Heat Offset
This setting adjusts how dark or light the fluorescent panel is printed. It has a range of +/- 20 .
Using the Lamination End of Form Option
This option changes head lift at end of card
Using the Lamination Temp Offset Option
This option changes Lamination Roller temperature.
Using the Lamination Bottom Takeup Option
This option changes tension of Laminate roll 1.
Using the Lamination Top Takeup Option
This option changes tension of Laminate rolls 2 (if equipped)