HID FARGO HDP8500 User Guide - Manual (Page 169)

© 2012 HID Global Corporation. All rights reserved.
169
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Remove Kiosk Jam
(PC Error Message
No. 296)
The printer is in kiosk mode
and a card is stuck under the
kiosk sensor. Clear the jam and press Cancel.
Remove Lam
Material
(PC Error Message
No. 210)
Single Sided Lam job
specified but the material is
loaded in both Modules. Remove either Lamination Cartridge.
Remove Lam1
Material
(PC Error Message
No. 204)
Single sided lamination on
the back side is specified but
material is loaded in the Lam
1 Module. Remove Cartridge 1.
Remove Lam2
Material
(PC Error Message
No. 205)
Single sided lamination on
the front side is specified but
material is loaded in the Lam
2 Module. Remove Cartridge 2.
Reject Bin Full
(PC Error Message
No. 265)
The reject bin is full. Remove the large number of rejected
cards from the reject bin.
Click OK to clear the notification
message. (Note: In some cases,
rejected cards are incomplete or pose
a security risk, and should be
disposed of properly.)
Ribbon Out
(PC Error Message
No. 91)
The print Ribbon has run
out. Install a new Ribbon and press
Resume to continue.
Ribbon Tension
(PC Error Message
No. 98)
The Ribbon tensions may be
out of range. Check and adjust the setting through
the TOOLBOX under the Advanced
Settings tab.
If this problem persists, call for
technical assistance. Press Resume
to continue or cancel to abort.
Shuttle Jam Error
(PC Error Message
No. 308)
The Input Hopper Card
Shuttle is jammed. Open the Printer's Cover.
Clear any cards in the Shuttle Module
by opening the Printers and follow this
direction.
#Case Open
Press the Resume button on the
Printer‟s Front Cover to continue