HID FARGO HDP8500 User Guide - Manual (Page 167)

© 2012 HID Global Corporation. All rights reserved.
167
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Lm1 Headlift Err
(PC Error Message
No. 217)
The Laminator failed to
move or sense the lower
(Lam module 1) head. Check head connections and call for
service/repair.
Lm2 Headlift Err
(PC Error Message
No. 218)
The Laminator failed to
move or sense the upper
(Lam Module 2) head. Check head connections, call for
service/repair.
Lam 1 Tag Error
PC Error Message
No. 219, 221)
RFID tag write error in lam
cartridge one.
RFID tag lock error in lam
cartridge one.
Verify the correct Laminate is installed
in the Lam 1 Cartridge.
Lam 2 Tag Error
PC Error Message
No. 220, 220)
RFID tag write error in lam
cartridge two.
RFID tag write error in lam
cartridge two.
Verify the correct Laminate is installed
in the Lam 2 Cartridge.
Lamination Calibrate
Temperature error
No 266
Lamination Module must be
warm before sending
Calibration option. If not an error will occur and will
trigger the laminator to warm up .
Retry the calibration again after
several minutes.
Mag Encoder Paused
(PC Error Message
No. 143)
The Magnetic Encoder is in
a pause state.
Mag Verify Error
(PC Error Message
No. 30)
Print could not verify MAG
write.
OR
The magnetic stripe was not
encoded properly. Check the Cards and click on Cancel
Print.
Remove card from printer and check
for debris or damage on the card. If
card still cannot be verified, reject
card.
Multiple Feed
(PC Error Message
No. 70)
Multiple cards were fed into
the Printer. Remove all cards and try again.
No Film
(PC Error Message
No. 28, 167)
Film is not installed in the
Printer.
OR
Film RFID tag is bad. Install the Film and press Resume.
To cancel the print, press the Cancel
Print button or the Cancel button
located on the Printer.
No Flip Module Two-sided job sent to a one- Verify the Printer has flipper