HID FARGO HDP8500 User Guide - Manual (Page 179)

© 2012 HID Global Corporation. All rights reserved.
179
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
No Laminator Film
Installed No laminator Film is
installed in the laminator
unit. Ensure that the appropriate
Laminator Film is installed.
To cancel the print, press the
Cancel Print button or the Cancel
button located on the Printer.
Wrong Laminator
Film Installed An incorrect laminator film
has been installed, or a
driver setting is incorrect. Ensure that the appropriate
Laminator Film is installed and
press the Resume button located
on the Printer to continue printing.
To cancel, press the Cancel Print
button or the Cancel button located
on the Printer.
Laminator Film Out The Film installed in the
laminator is empty. The Film installed in the laminator is
empty.
Laminator Film
Break/Jam A Film break/jam has
been detected inside the
Laminator. The printer has determined that one
or both overlaminate films have
either jammed or broken.
a. Open the Laminator Cover and
remove the Laminator
Cartridge(s). If overlaminate is
jammed, remove jam and tighten
the material
b. Clear any cards in the printer by
using the Forward and/or Back
buttons located on the Printer's
LCD display.
c. Tape the ends of the
overlaminate together and wind
any excess onto the Take-up
Spool of the Overlaminate.
d. Re-install the Laminator
Cartridge(s), close the Laminator
Cover and press the Resume
button located on the Printer's
LCD display to continue printing.
e. To cancel the print, press the
Cancel Print button from the
Driver's display dialog and the
Cancel button located on the
Printer's LCD display.
Laminator Film The Laminator cannot find
the next panel on the Check that the Film is installed