JLG X700AJ Operator Manual - Manual (Page 111)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3128790 – JLG Lift – 6-15
Replacing Rubber Tracks
1. Elevate the machine on firm, level and uniform surface
utilizing the outriggers.
2. Remove the screws and remove cover 3 as shown in fig-
ure.
3. To loosen the track, slowly unscrew valve 1 in a counter-
clockwise direction. Do NOT exceed one (1) rotation.
4. Allow grease to drain. If grease does not drain, slowly
rotate the track.
5. Insert three steel pipes 4 between the rollers of the track.
Turn the driving wheel backwards 5 to engage the track
tensioning wheel. Apply an outward force 6 to lift the
track from the track tensioning wheel.
Installation of Rubber Track
1. Ensure all hydraulic cylinder grease have been removed
2. Align the track links with the wheel teeth. Position the
other end of the track on the track tensioning wheel
3. Slowly rotate the drive wheel in reverse while, using one
steel pipe, pushing the track plate inside the frame.
4. Verify the track links have engaged the wheel teeth in the
track tensioning wheel
5. Adjust track tension (see Loosening/Tightening track
section).
3
1
2
4
5
6