JLG X700AJ Operator Manual - Manual (Page 88)

SECTION 5 - EMERGENCY PROCEDURES
5-8 – JLG Lift – 3128790
TO AVOID CONTACT BETWEEN THE JIB AND OUTRIGERS, DO NOT
ATTEMPT TO MANUAL SWING WITH THE BOOMS AND JIB FULLY
LOWERED.
f. Swing turntable inline with the chassis so that the
turntable and base indicator arrows are aligned.
NOTE: This will eliminate the possibility of an elevated or
extended boom being positioned overhead of person-
nel at the pump and eliminate the risk of lowering the
jib onto an outrigger.
With the aid of an assistant, activate the swing control
lever, located behind the diverter valve in the handpump
compartment, in the desired direction of travel while
pumping the hand pump until the turntable is aligned
with the chassis.
Activating the lever downward while pumping will swing
the platform to the left.
Activating the lever upward while pumping will swing the
platform to the right.
2. Retract the main boom (if necessary).
With the aid of an assistant, while pumping the hand
pump, activate the telescope function lever (Item 7, Fig-
ure 5-2.) at the ground controls on the opposite side of
the machine, to retract the main boom.
If no assistant is available, the valve tool must be
installed on the telescope in valve solenoid.
a. To activate telescope in, remove the black thumb-
screw on the solenoid and install the valve tool on
the telescope in solenoid (Item 7, Figure 5-2.).
b. Pump the handle until the main boom is fully
retracted.
c. Remove the valve tool from the telescope in sole-
noid.
d. Reinstall the black thumbscrew on the solenoid.
3. Lower the jib.
With the aid of an assistant, while pumping the hand-
pump, activate the jib lift function lever (item 8, Figure 5-
2.) in the appropriate direction to lower the jib.
If no assistant is available, the valve tool must be
installed on the jib lift down solenoid.