JLG X700AJ Operator Manual - Manual (Page 87)

SECTION 5 - EMERGENCY PROCEDURES
3128790 – JLG Lift – 5-7
Manual Descent without Engine and Electrical
Power.
Using Hand Pump in Hydraulic Compartment on Right
side of Machine
1. Platform retrieval sequence.
Ensure the machine is level and all outriggers are prop-
erly deployed on a firm surface.
a. Remove the hydraulic panel cover on the right front
side of the machine and locate the valve tool, black
thumbwheel, and thumbwheel installation screw in
the plastic bag (item 1).
b. Install the black thumbwheel on the diverter valve
(item 2) located near the rear of the hydraulic com-
partment. Secure the thumbwheel to the valve shaft
with the screw provided in the bag with the valve
tool.
c. Open the diverter valve by turning the thumbwheel
in the clockwise direction until it stops.
d. Locate the pump handle secured to the inside of the
hydraulic compartment cover.
e. Install the pump handle on the pump (item 3) and
secure in place with the provided screw. The lever
on the pump must be set to the right.
NEVER WORK UNDER AN ELEVATED PLATFORM UNTIL PLAT-
FORM HAS BEEN SAFELY RESTRAINED FROM ANY MOVEMENT BY
BLOCKING OR OVERHEAD SLING.
NEVER REACH THROUGH, UNDER, OR OVER THE BOOM' S PATH
OF TRAVEL TO THE GROUND CONTROL PANEL. IF NO ASSISTANT
IS AVAILABLE, PROCEED WITH THE FOLLOWING STEPS.
Figure 5-4. Hand Pump - Control Valve Tray