JLG X700AJ Operator Manual - Manual (Page 61)

SECTION 4 - MACHINE OPERATION
3128790 – JLG Lift – 4-15
If one of the outriggers does not come into contact with the
ground while being set, the engine will turn off or, the self-lev-
elling attempt will stop. This situation may be due to the slope
on which the outriggers are being set up on exceeds the
allowed slope for proper set up at the end of the stabilization
phase. If the machine is to be lifted even further from the
ground after the outriggers are properly set, push and hold the
outrigger automatic set and level button. If the functions are selected when one of the above listed con-
ditions is missing, an error message will appear on the plat-
form/remote control display indicating which of the conditions
are OK and which are not. If the condition is that an outrigger
is not set properly, the message will also indicate which outrig-
ger is not set properly.
ST1: if OK outrigger 1 is set properly.
ST2: if OK outrigger 2 is set properly.
ST3: if OK outrigger 3 is set properly.
ST4: if OK outrigger 4 is set properly.
INCL: if OK the machine is set up on an accepted slope.
LOAD: if OK the load in the platform is acceptable.
PLATFORM: if OK the platform/remote control box is in the
proper location in the platform.
PEDAL: If OK the footswitch is correctly depressed.