JLG X700AJ Operator Manual - Manual (Page 62)

SECTION 4 - MACHINE OPERATION
4-16 – JLG Lift – 3128790
Setting Outriggers From the Platform/Remote
Console
(Reference Figure 4-6. for item numbers)
Either - Press and hold the outrigger auto-
set and level button 7 (item 7) until OK
appears on the platform LCD display.
or
Operate each outrigger separately by
pressing button 2 (item 2) to select which
outrigger to control (each outrigger is num-
bered 1 thru 4, see decal, each press of but-
ton 2 displays the outrigger selected on the
LCD display). Press button 1 (item 1) to
retract or button 7 (item 7) to set that outrig-
ger. The OK will appear on the display when
the outriggers are set properly and the unit
is level.
Note: To cycle back to outrigger auto-set
mode, press button 2 (item 2) until the LCD
display shows the normal operating icons.
CHECK THE BUBBLE LEVEL TO CONFIRM UNIT IS LEVEL (BUBBLE
IS IN THE 1° GREEN (CENTER) AREA) AND THAT THE TRACKS ARE
OFF THE GROUND BEFORE OPERATING THE BOOM FUNCTIONS. IF
THE BUBBLE IN THE LEVEL IS NOT IN THE GREEN AREA, AFTER
USING THE AUTO-LEVEL FUNCTION, SHUT DOWN THE MACHINE
AND HAVE THE MACHINE REPAIRED BY A QUALIFIED SERVICE
TECHNICIAN.
Each outrigger has a yellow light installed. All lights will be on
steady if the outriggers are positioned to the full operation
area. The lights will be flashing if any of the outriggers are
positioned in the restricted operation area. No lights will be on
if the outriggers are not set properly.
AUTO
7
MANUAL
SELECT
2