JLG X700AJ Operator Manual - Manual (Page 35)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3128790 – JLG Lift – 3-5
Control Position From In The Platform:
The platform/remote control is connected to the machine at
the platform using a flexible cable.
Always remember to close the platform/remote control station
lid when not in use.
NOTE: Before removing or connecting the flex cable, the
machine must be turned OFF and the key on the
engine must be in the OFF position.
Installing the Platform/Remote Control Station At The Plat-
form
1. Connect the flexible control cable at the platform to the
Platform/Remote Control Station box connector on the
right side of the control box.
.
2. In the platform, slide the control station assembly into the
storage box and place the rib on the left side of the con-
trol station assembly under the metal tab attached to the
storage box assembly.
3. Lower the control station assembly into the storage box,
on the right side of the control station ensure the
attached flexible cable slides into the slot in the box.
Secure this side of the control station by turning the
thumbscrew on the locking tab counterclockwise locking
the rib of the control station under the rotating metal tab
of the thumbscrew.