JLG X700AJ Operator Manual - Manual (Page 117)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3128790 – JLG Lift – 6-21
Errors Menu
Indicates the agreement (OK) or not (FAULT) status of the
sensors that have a double control.
The sensors are listed on two pages;
The sensors are listed on different pages:
1 - PREV - access the previous input
2 - NEXT - access the successive input
9 - ESC - escape from the INPUT menu
If the OK symbol appears at the side of the sensor it means
that the two elements of the same sensor send congruent
information.
If the FAULT symbol appears at the side of the sensor it
means that the two elements of the same sensor send incon-
gruent information.
Working Hours Menu
Indicates the number of machine working hours.
Set-up Menu
The items in this menu cannot normally be accessed.
Joystick Menu
Displays the signal that each individual Joystick sends to the
main board.
POSM 3A Both ON indicates the stabilizer 3 is in stabilization posi-
tion.
POSM 3B
POSM 4A
Both ON indicates the stabilizer 4 is in stabilization posi-
tion.
POSM 4B
R.C. PLATFORM ON position indicates the remote control is in its mount.
(in the platform).
INCLIN. X Indicates the inclination of X axis in tenths of a degree.
INCLIN. Y Indicates the inclination of Y axis in tenths of a degree.
LOAD Indicates the weight in the platform in pounds.
POS. 1E2 Indicates 1° and 2° arm cylinder stroke in tenths of a mil-
limeter.
POS. 3 Indicates 3° arm cylinder stroke in tenths of a millimeter.
ROTATION A Indicates the angular position of the aerial part in
degrees (180° - aligned photocells).
MOTOR RPM Indicates the engine speed.
CURRENT A Indicates the power to proportional valve.
CURRENT B Indicates the power to proportional valve.
CURRENT C Indicates the power to proportional valve.
TEMPERAT. Indicates the temperature measured by the electrical
probe.
SUPPLY (V) Indicate the voltage (In volts).