JLG X700AJ Operator Manual - Manual (Page 13)

SECTION 1 - SAFETY PRECAUTIONS
3128790 – JLG Lift – 1-3
Machine Inspection
• Before machine operation, perform inspections and
functional checks. Refer to Section 2 of this manual for
detailed instructions.
• Do not operate this machine until it has been serviced
and maintained according to requirements specified
in the Service and Maintenance Manual.
• Be sure all safety devices are operating properly. Mod-
ification of these devices is a safety violation.
MODIFICATION OR ALTERATION OF AN AERIAL WORK PLATFORM
SHALL BE MADE ONLY WITH WRITTEN PERMISSION FROM THE
MANUFACTURER.
• Do not operate any machine on which safety or
instruction placards or decals are missing or illegible.
• Check the machine for modifications to original com-
ponents. Ensure that any modifications have been
approved by JLG.
• Avoid any buildup of debris on the platform floor. Keep
mud, oil, grease, and other slippery substances from
footwear and platform floor.
1.3 OPERATION
General
• Do not use the machine for any purpose other than
positioning personnel, their tools, and equipment.
• Never operate a machine that is not working properly.
If a malfunctions occurs, shut down the machine.
• Never slam a control switch or lever through neutral to
an opposite direction. Always return switch to neutral
and stop before moving the switch to the next func-
tion. Operate controls with slow and even pressure.
• Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the plat-
form, except in an emergency.
• Do not carry materials directly on platform railing
unless approved by JLG.
• When two or more persons are in the platform, the
operator shall be responsible for all machine opera-
tions.
• Always ensure that power tools are properly stowed
and never left hanging by their cord from the platform
work area.
• Supplies or tools which extend outside the platform
are prohibited unless approved by JLG.