JLG X700AJ Operator Manual - Manual (Page 19)

SECTION 1 - SAFETY PRECAUTIONS
3128790 – JLG Lift – 1-9
• Be aware of stopping distances in all drive speeds.
When driving in high speed, slow down the machine
using the controllers before stopping.
• Do not use high speed drive in restricted or close
quarters or when driving in reverse.
• Under all travel conditions, the operator must limit
travel speed according to conditions of ground sur-
face, congestion, visibility, slope, location of person-
nel, and other factors causing hazards of collision or
injury to personnel.
• Exercise extreme caution at all times to prevent obsta-
cles from striking or interfering with operating controls
and persons in the platform.
• Be sure that operators of other overhead and floor
level machines are aware of the aerial work platform’s
presence. Disconnect power to overhead cranes.
• Warn personnel not to work, stand, or walk under a
raised boom or platform. Position barricades on floor if
necessary.
1.4 LIFTING, AND HAULING
• Never allow personnel in platform while lifting or haul-
ing the machine.
• Ensure boom is in the stowed position prior to lifting or
hauling. The platform must be completely empty.
• When lifting machine, lift only at designated areas of
the machine. Lift the unit with equipment of adequate
capacity.
• Refer to the Machine Operation section of this manual
for lifting information.
1.5 ADDITIONAL HAZARDS / SAFETY
• Do not use machine as a ground for welding.
• When performing welding or metal cutting operations,
precautions must be taken to protect the chassis from
direct exposure to weld and metal cutting spatter.
• Do not refuel the machine with the engine running.
• Battery fluid is highly corrosive. Avoid contact with
skin and clothing at all times.
• Charge batteries only in a well ventilated area.