JLG X700AJ Operator Manual - Manual (Page 81)

SECTION 5 - EMERGENCY PROCEDURES
3128790 – JLG Lift – 5-1
SECTION 5. EMERGENCY PROCEDURES
5.1 GENERAL
This section explains the steps to be taken in case of an
emergency situation while operating.
5.2 INCIDENT NOTIFICATION
JLG Industries, Inc. must be notified immediately of any
incident involving a JLG product. Even if no injury or
property damage is evident, the factory should be con-
tacted by telephone and provided with all necessary
details.
In USA -
JLG Phone:
877-JLG-SAFE (554-7233)
(8am till 4:45pm EST)
Outside USA: 240-420-2661
E-mail: [email protected]
Failure to notify the manufacturer of an incident involving
a JLG Industries product within 48 hours of such an
occurrence may void any warranty consideration on that
particular machine.
FOLLOWING ANY ACCIDENT, THOROUGHLY INSPECT THE
MACHINE AND TEST ALL FUNCTIONS FIRST FROM THE GROUND
CONTROLS, THEN FROM THE PLATFORM CONTROLS. DO NOT LIFT
ABOVE 3 M (10 FT.) UNTIL YOU ARE SURE THAT ALL DAMAGE HAS
BEEN REPAIRED, IF REQUIRED, AND THAT ALL CONTROLS ARE
OPERATING CORRECTLY.
5.3 EMERGENCY OPERATION
Power Main Cut-Off Switch Location
A battery cut-off switch - RED handle (photo shows power
ON) is located on the outside of the battery/electrical box
tray at the left front of the machine just behind the outrigger
mount. When switched off - handle turn all the way in direc-
tion of arrow - all electrical power to the machine is shut
down.