JLG X700AJ Operator Manual - Manual (Page 63)

SECTION 4 - MACHINE OPERATION
3128790 – JLG Lift – 4-17
IF ONE OF THE ORANGE LIGHTS LOCATED ON EACH OUTRIGGER
SHOULD FLASH OR REMAIN ON WHEN THAT OUTRIGGER IS LIFTED
FROM THE GROUND, STOP THE MACHINE IMMEDIATELY AND CALL
A QUALIFIED JLG SERVICE TECHNICIAN AS THIS INDICATES A
PROBLEM WITH THE CORRESPONDING OUTRIGGER MICRO
SWITCH.
IF THE SLOPE EXCEEDS 13°, THE MACHINE IS NOT CAPABLE OF
PROPERLY SETTING THE OUTRIGGERS AND LEVELING ITSELF.
OPERATION OF THE BOOM AND PLATFORM FUNCTIONS WILL NOT
BE ALLOWED IN THIS CONDITION. THE MACHINE IS CONSIDERED
STABILIZED WHEN LEVELED TO LESS THAN 1° AND THE TRACKS
ARE LIFTED AT LEAST 2 IN. (5 CM) FROM THE GROUND.
STABILIZING THE MACHINE WITH AN INCLINATION DEGREE
HIGHER THAN THE ONE ALLOWED COULD CAUSE INSTABILITY OF
THE MACHINE
If the platform ladder is higher than 16 in. (40 cm) off the
ground when the ladder is lowered, when setting the machine
on outriggers from the ground position, lower the outriggers
until the ladder is less than 16 in. (40 cm) off the ground. Then
enter the platform to properly set the machine up on outrig-
gers.
Retracting The Outriggers
(Reference Figure 4-6. for item numbers)
Either - Press and hold button no. 1 (item 1)
of the remote control.
The 4 outriggers will all retract at the same
time and lower the machine.
or
Operate each outrigger separately by
pressing button 2 (item 2) to select which
outrigger to control (each outrigger is num-
bered 1 thru 4, see decal at each outrigger,
each press of button 2 displays the outrig-
ger selected on the LCD display). Press but-
ton 1 (item 1) to retract or button 7 (item 7)
to set that outrigger.
Note: To cycle back to outrigger auto-
retract mode, press button 2 (item 2) until
the LCD display shows the normal operating
icons.
AUTO
1
MANUAL
SELECT
2