JLG X700AJ Operator Manual - Manual (Page 97)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3128790 – JLG Lift – 6-1
SECTION 6. GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6.1 INTRODUCTION
This section of the manual provides additional necessary
information to the operator for proper operation and mainte-
nance of this machine.
The maintenance portion of this section is intended as infor-
mation to assist the machine operator to perform daily main-
tenance tasks only, and does not replace the more thorough
Preventive Maintenance and Inspection Schedule included in
the Service and Maintenance Manual.
IT IS GOOD PRACTICE TO AVOID PRESSURE-WASHING ELECTRI-
CAL/ELECTRONIC COMPONENTS. IN THE EVENT PRESSURE-
WASHING THE MACHINE IS NEEDED, ENSURE THE MACHINE IS
SHUT DOWN BEFORE PRESSURE-WASHING. SHOULD PRESSURE
WASHING BE UTILIZED TO WASH AREAS CONTAINING ELECTRI-
CAL/ELECTRONIC COMPONENTS, JLG INDUSTRIES, INC. RECOM-
MENDS A MAXI MUM PRESSURE OF 750 PSI (52 BAR) AT A
MINIMUM DISTANCE OF 12 INCHES (30.5 CM) AWAY FROM THESE
COMPONENTS. IF ELECTRICAL/ELECTRONIC COMPONENTS ARE
SPRAYED, SPRAYING MUST NOT BE DIRECT AND BE FOR BRIEF
TIME PERIODS TO AVOID HEAVY SATURATION.