JLG SSV10 Service Manual - Manual (Page 32)

SECTION 3 - BASE COMPONENTS
3-4 – JLG Lift – 3121187
(Rear) Drive Motor Wheel - Installation (Front) Caster Wheel - Installation
Drive Wheel Installation
1. Wheel Hub Cover
2. Cotter Pin
3. Nut Lock Shield
4. Wheel Nut (b) 5. Washer
6. Wheel/Hub (a)
7. Drive Motor Shaft (a)
8. Shaft Key (c)
NOTE: (a) Coat the drive motor shaft and the inside of the
wheel hub with Loctite Moly Paste Lubricant #51049
(JLG P/N- 3020039) before assembly.
(b) On final assembly apply Loctite #242 to threads
before tightening to 100 ft. lb.
(c) Lightly tap key into keyway on shaft, check that flat
on key is parallel with shaft before installing wheel.
6
8
Front Caster Wheel Installation
1. Snap Ring
2. Upper Bearing (a)
3. Lower Bearing (a)
4. Spindle Shaft Seal 5. Spindle/Axle Assy.
6. Caster Wheel (b)
7. Snap Ring (c)
NOTE: Base shown cutaway for illustrative purposes only.
(a) If replacing bearing, pack bearing completely full of
grease before assembling, use (JLG P/N-3020029 -
Mobil SHC 460 Synthetic or equivalent), tap in evenly
until seated.
(b) Coat the axle shaft with Loctite Moly Paste lubricant
before assembling wheel. Axle bearings on wheel are
maintenance free.
(c) After installing the wheel and just before installing
the Snap Ring, wipe the end of the axle clean and coat
the end of the axle with Clear Varnish.