JLG SSV10 Service Manual - Manual (Page 74)

SECTION 5 - MAST COMPONENTS
5-2 – JLG Lift – 3121187
5.2 MAST COVER - INSTALL/REMOVE 5.3 PLATFORM ASSEMBLY - INSTALL/
REMOVE
Mast Cover Installation
1. Mast Cover
2. Screws and Washers (a) 3. Platform Console Mount-
ing Screws
Platform shown without right side rails for illustra-
tive purposes only.
Note: (a) Apply Loctite #242 to threads before final tightening.
Platform Installation
1. Platform/Material Tray
Assembly
2. Tie Straps for Platform
Console Harness
3. Countersunk Flat Head
Socket Screws/Washers
and Locknuts
4. Hex Head Screws/Wash-
ers and Locknuts (a)
Platform shown without right side rails and plat-
form floor cutaway for illustrative purposes only.
Note: (a) Raise platform and remove the hex head screw/wash-
ers and nuts (item 4).
While under the platform, unplug the wiring harness to
the foot enable switch and the entry gate interlock
switches from the platform junction box.
Using suitable lifting equipment carefully lift the plat-
form/material tray assembly off the mast assembly.