JLG SSV10 Service Manual - Manual (Page 63)

SECTION 4 - CONTROL COMPONENTS
3121187 – JLG Lift – 4-9
Power Selector/EStop Switch Installation
Emergency Stop Switch Installation
1. Emergency Stop Button 4. Nut
2. Button Seal
5. Emergency Stop Switch
3. Square Lock Washer 6. Switch Lock/Release Lever
Note: Tighten nut enough to keep button from turning.
Reattach wires to same terminals on new switch.
Power Selector Switch Installation
1. Selector Knob 3. Power Selector Switch
2. Nut 4. Align and insert tab into cover
Note: Reattach wires to the same terminals on new switch.
EStop/Power Selector Switch Connector Locations
1. LCD and Button Circuit Board
2. Emergency Stop Switch Connector
3. Main Power Selector Switch Connector
Note: To release switch connectors, push tab on top of connector.
2
3
1