JLG SSV10 Service Manual - Manual (Page 49)

SECTION 3 - BASE COMPONENTS
3121187 – JLG Lift – 3-21
Battery Charger Installation
1. Remove the front cover from the machine. (See
Page 3-2)
2. Disconnect the positive (+) battery cable at the left
side battery.
3. Remove the four (4) capscrews and washers on the
front of the charger securing it to the base frame
charger mount.
4. Lift charger up and lay on it’s side to disconnect the
wiring connectors from the back of the charger
assembly. Move the charger to a suitable work sur-
face.
Battery Charger - Remove/Install
1. Battery Charger Assembly
2. Charger Capscrews/Washers (4)
1
1
2
Battery Charger - Rear Panel Connections
1. Wet/VRLA Selector Switch 4. To Charging Status LED
2. To AC 120/220Volt Input
Indicators (On Rear Bumper)
Socket (On Rear Bumper) 5. DC Voltage Output to Battery
3. Drive Cut-Out Wires to P2 +/– Posts (See Below)
Connector on Ground Control
Station
1 2 3 4
5
(+ )
(– ) (+ )
(– )
MACHINE FRONT
5