JLG SSV10 Service Manual - Manual (Page 47)

SECTION 3 - BASE COMPONENTS
3121187 – JLG Lift – 3-19
Battery Charge LED Indicator on Platform
Control Console
On normal power-up and operation this series of ten
(10) LEDs visually indicates the amount of charge
remaining in the batteries.
The number of LEDs lit will change depending on the
level of charge in the batteries.
•(+) All Three (3) GREEN LEDs lit up indicate maxi-
mum battery charge.
•Four (4) YELLOW LEDs indicate a two thirds to one
third battery charge remaining.
•(–) Three (3) RED LED’s lit indicate minimum battery
charge remaining. The machine will continue to
operate at this charge level but will begin to indicate
battery low voltage warning indicators.
Battery Low Voltage Warning Indicators
The Platform Control Console and Ground Control Station
indicate battery low voltage at three (3) Warning Levels.
(See Table 3-1. following).
Table 3-1. Battery Low Voltage Warning Indicators.
WARNING
LEVEL
INDICATOR LOCATION
RESULT
ACTION REQUIRED TO
CLEAR FAULT
PLATFORM CONTROL LED GROUND CONTROL LCD
LEVEL-1 • 3 LEDs/BARS Flashing
with an audible beep.
• Machine will Operate - No
Control Functions Locked
Out.
Charge batteries to a level of
four (4) LEDs/BARS or more
before operating.
LEVEL-2 • 2 LEDs/BARS Flashing
with an audible beep.
• Platform Lift-UP Function
is Locked Out.
Charge batteries for a mini-
mum of four (4) continuous
hours or more, or (8) LEDs/
BARS lit before operating. (a)
LEVEL-3 • 1 LED/BAR Flashing with
an audible beep.
• Drive and Platform Lift-UP
Functions Locked Out.
Charge batteries for a mini-
mum of four (4) continuous
hours or more, or (8) LEDs/
BARS lit before operating. (a)
NOTE: (a) To maximize battery life, it is recommended that the factory supplied batteries be charged continuously for a minimum of 4 hours or
until 8 bars are lit on the ground station LCD Display before operating the machine. When drained to Warning Level 2, batteries must be
charged until 8 bars are lit on the ground station LCD display to clear the fault code.