JLG SSV10 Service Manual - Manual (Page 41)

SECTION 3 - BASE COMPONENTS
3121187 – JLG Lift – 3-13
Drive Motor - Boot Installation Drive Motor - Brake Location
A brake assembly is mounted to the end of the drive
motor housing. The brakes are ENGAGED (brakes on)
when the machine is parked and are RELEASED electri-
cally (brakes off) when the joystick is enabled and pushed
in any direction. The brakes can also be RELEASED elec-
trically using the manual brake release button on the
ground control station.
NOTE: The brakes are intended only as a parking brake to keep the
machine from moving while at rest. The brakes are not used
to stop the machine during driving operations, this braking is
controlled by the drive motors themselves. Under normal
driving conditions, once released the brakes are not engaged
again until the machine comes to a complete stop.
Drive Motor Boot - Installation
1. Boot - (Shown Cutaway)
2. Boot Clamp 3. Drain Hole (a)
4. Power Cable Sleeve/Clamp
NOTE: When removing, loosen clamps, slide boot clamp for-
ward on motor, pull bottom of boot up over brake and
slide up harness sleeve.
(a) If replacing the boot assembly with a new one,
check the bottom of the boot for a drain hole. If none
exists, cut a drain hole approximately 1/8 inch (3mm)
size on the BOTTOM of the new boot. This will allow
any accumulated condensation to drain out and not
remain trapped there.
Drive Motor Brake Location
1. Drive Motor Brake
2. Boot - (Shown Cutaway) 3. Motor/Brake Power Cable