JLG SSV10 Service Manual - Manual (Page 82)

SECTION 5 - MAST COMPONENTS
5-10 – JLG Lift – 3121187
5.9 MAST ASSEMBLY
Assembly procedures for all mast sections is basically the
same, carefully slide the mast sections together until mast
ends are even. (When sliding the mast sections together,
be careful not to scratch the anodized surface in the wear
pad channels). Assemble the hardware to the bottom of
mast section first, slide this section out the top of previous
section and assemble hardware to the top of mast. Always
install slide pad shims with slide pads inserted into the
slide pad channels, (ends of mast sections even). Apply-
ing Krytox spray (JLG P/N-3020041) onto the slide pads
and slide pad channels before assembly will help mast
sections slide easier after slide pads have been properly
shimmed.
Figure 5-4. Mast Section - Assembly Reference.
OPEN RAIL
(REFERS TO OPEN RAIL
FRONT OF MAST SECTION)
CLOSED RAIL
(REFERS TO CLOSED RAIL
BACK OF MAST SECTION)
BOTTOM
(REFERS TO BOTTOM END OF
MAST SECTION WHICH SETS IN
MACHINE’S BASE FRAME)
TOP
(REFERS TO TOP END
OF MAST SECTION
WHERE COVER AND
SHEAVE WHEELS
ARE ATTACHED)