JLG SSV10 Service Manual - Manual (Page 50)

SECTION 3 - BASE COMPONENTS
3-22 – JLG Lift – 3121187
Battery Charger Cover Installation
General Component Installation Notes
When removing components make note of the wiring con-
nections before disconnecting the wiring between the
components within the charger assembly. Only discon-
nect enough wiring to remove a component.
The battery charger manual supplied with the machine
contains a wiring diagram for the charger as well as Figure
3-3. at the end of this section of the manual.
Battery Charger Cover - Remove/Install
1. Charger Cover 2. Bottom Tray Screws (Removal Optional) 3. Screws - Same on Both Sides
2
3
1