Lenze E84Dxxxxx - Manual (Page 18)

2 Introduction
2.4 Parameter setting and configuration
18
Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.4 Parameter setting and configuration
If you select the safety option in the project view of the »Engineer«, different tabs for the safety
system are available in the workspace. The following illustration shows the tabs for safety
option 30:
[2-1] Tabs of the integrated safety system (here as an example for safety option 30)
Safe parameter transfer
By clicking Safe Transfer on the Safe configuration tab, the Safe Transfer dialog box opens which
provides the function for a safe parameter transfer.
 Safe parameter transfer ( 44)

Note!
Safety-relevant parameters can only be transmitted to the drive-based safety system via
safe parameter setting with the »Engineer«.
The parameter set is stored in the memory module and in the drive-based safety system
with a unique module ID, which must correspond to the effective safety address in the
drive-based safety system.
Tab Information available for
safety soption
10 20 30
Safe configuration This tab serves to make the safe configuration of the drive-
based safety.
 Safe configuration ( 22)
 
Features This tab displays general information on the safety system,
e.g. product name, version, etc.
  
Documentation This tab serves to add notes and electronic documents to the
drive-based safety system.
• Detailed information on adding documentations can be
found in the »Engineer« documentation in chapter
"Project structure".
  