Lenze E84Dxxxxx - Manual (Page 55)

Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05
55
7 Parameter reference
7.1 Parameter list | C15033
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C15033
C15034
C15035
C15036
Parameter | Name:
C15033 | SD-In Discrepancy time
Data type: UNSIGNED_16
Index: 9542
d
= 2546
h
Maximum time for which both channels of a safe input may have non-equivalent states without the safety
engineering detecting an error.
Display range
(min. value | unit | max. value)
0 ms 30000
Subcodes Information
C15033/1 SD-In1 discrepancy time
C15033/2 SD-In2 discrepancy time
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C15034 | SD-In Input delay
Data type: UNSIGNED_8
Index: 9541
d
= 2545
h
Time between the recognition of the signal change and the effective evaluation of an input signal. As a result,
multiple and short signal changes due to contact bounce of the components are not taken into account.
Display range
(min. value | unit | max. value)
0 ms 100
Subcodes Information
C15034/1 SD-In1 input delay
C15034/2 SD-In2 input delay
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C15035 | C15035
Data type: UNSIGNED_8
Index: 9540
d
= 2544
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C15036 | C15036
Data type: UNSIGNED_16
Index: 9539
d
= 2543
h
This code is for device-internal use only and must not be written to by the user!