Lenze E84Dxxxxx - Manual (Page 33)

Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05
33
3 Safe configuration
3.6 Safety bus
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.6 Safety bus
The drive-based safety system provides parameterisable interfaces for standardised safety bus
systems. By selecting the bus system, the corresponding parameters are made available.
Short overview of "Safety bus" parameter group:
S bus: Configuration
Selection of the safety bus system used. Communication modes that are currently being supported:
• Operation without safety bus
• Operation with PROFIsafe protocol
S bus: Filter control data
Unused functions in the control data of the safety bus must be set to "Inhibit" via this parameter.
Then, these functions cannot be activated anymore via the safety bus independently of the
transmitted control data.
Parameter Information Lenze setting
C15100 S bus: Configuration No safety bus
C15113 S bus: Filter control data (bit-coded):
Bit 0 STO Passing through
Bit 1 SS1 Passing through
Bit 9 ES Passing through
Bit 11 OMS Passing through
Bit 16 PS_AIS Passing through
Bit 17 PS_AIE Passing through
Bit 23 SSE Passing through
Unlisted bits are reserved for future extensions!