Lenze E84Dxxxxx - Manual (Page 48)

6 Safe parameter transfer
6.5 General reset of device
48
Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.5 General reset of device
A general reset is, among other things, required for initialising the memory module if the controller
(with the memory module) is used together with the drive-based safety system for the first time.

How to execute a general reset of the device:
1. Unless there is an online connection, establish an online connection to the device.
2. Go to the advanced Safe transfer dialog box and click As-delivered.
• The Standard password entry dialog box is displayed.
3. Enter the standard password and confirm with OK.
• The standard password is "Lenze SM301".
The general reset is executed and then a status message displays whether the action could
be carried out successfully.
4. Confirm the status message with OK.

Note!
This function serves to reset the safety system to the delivery status.
• The safe parameter set in the memory module and in the drive-based safety system is
deleted.
• The password file required for the safe parameter transfer is re-created in the memory
module. This causes the individual device password defined before to be reset to the
standard password.
• Afterwards the drive-based safety system must be re-parameterised.