Lenze E84Dxxxxx - Manual (Page 26)

3 Safe configuration
3.4 General parameters
26
Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.4.1 Setting of the safety address
The safety address can be set via the "Safety address" parameter ( C15111 ).
Setting via parameter setting
• Via the parameter "safety address" ( C15111 ) addresses in the range of 0 ... 65534 can be set.
Effective safety address
The effective safety address is the result of the setting via parameter setting.
• The effective safety address must match the module ID assigned in the safe parameter set.
• If "PROFIsafe" has been selected as safety bus, the effective safety address is accepted
simultaneously as the PROFIsafe target address. This address must match the corresponding
configuration of the safety PLC.

Tip!
C15112 displays the effective safety address.