RKI Instruments Gas Tracer 10,000 ppm - Manual (Page 96)

89 • Replacing or Recharging the Batteries10,000 ppm Gas Tracer Operator’s Manual
Figure 17: Putting the Gas Tracer into the Charging Station
5. When a full charge has been reached, approximately 4 hours, the
red LED on the charging station will turn off. Remove the Gas
Tracer from the charging station and unplug the charging station’s
power cord from the AC outlet.
Recharging the Lithium Ion Battery Pack Out of the
Instrument
The lithium ion battery pack may be charged using the charging
station while it is out of the Gas Tracer. This is useful if spare battery
packs are kept in case the pack in the Gas Tracer needs to be charged,
but the unit must be used immediately. In this case, a spare charged
pack can be installed in the Gas Tracer and the dead pack charged in
the charging station.
1. Make sure the Gas Tracer is off.
2. Confirm that the adapter’s DC output cord is plugged into the
charger.
Red Charging LED