Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 21)

Installation
This chapter describes installation of the RAC6182 Industrial Computer
for the Windows CE Operating System, including how to install the
RAC6182 Industrial Computer in a panel using mounting clips.
The RAC6182 Industrial Computer meets the European Union Directive
requirements when installed within the European Union or EEA regions
and has the CE mark. A copy of the Declaration of Conformity is
available at the Rockwell Automation/Allen-Bradley Internet site:
www.ab.com
Mount the RAC6182 Industrial Computer in a panel or enclosure to
protect the internal circuitry. Versions with a gasketed bezel meet
NEMA Type 1, 12, 13 and 4X (Indoor use) and IEC IP54, IP65 only
when properly mounted in a panel or enclosure having an equivalent
rating. The non-display version does not have a gasket and has a NEMA
Type 1 and IEC IP2X rating.
Allow enough room within the enclosure for adequate ventilation. Also
consider heat produced by other devices in the enclosure. The ambient
temperature around the RAC6182 Industrial Computer must be
maintained between 0
o and 50 o C (32 o to 122 o F). The RAC6182
Industrial Computer is intended for use in Pollution Degree 2
environments.
Make sure you provide provisions for accessing the top, bottom, and side
panels of the RAC6182 Industrial Computer to install/remove
components and to access the connectors.
Versions of the RAC6182 Industrial Computer with a display are shipped
with the following mounting hardware:
Table B
Mounting Hardware
Item Description Quantity Use For
Mounting
Clips 4 Clips Panel or enclosure
mounting
Chapter
2
Chapter Objectives
European Union
Compliance
Environmental
Considerations
Mounting Hardware