Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 55)

Installing/Removing Front Bezel Assembly Items 5–5
Publication 6182-UM001D-EN-P
8. Reconnect the backlight tube connectors and backlight power supply
cable.
9. Reinstall the 6 screws to attach the metal cover to the metal frame.
Tighten the screws to a torque of 6 - 8 in–lbs (0.7 - 0.9 N•m).
10. Follow the procedures on Page 4-2 to reassemble the front bezel
assembly to the computer chassis.
The plastic overlay on the RAC6182 Industrial Computer is field
replaceable. You may need to replace the bezel if the bezel or a portion
of a keypad is damaged. The plastic overlay assembly includes the
plastic bezel, overlay, and legend strips only.
To replace the front bezel overlay:
1. Follow the procedures in this chapter to disassemble the front bezel.
2. On the new plastic overlay assembly, remove any protective film
from the inside display window. Be careful to keep this surface
clean, as it cannot be cleaned once assembled.
3. If you are replacing the bezel overlay on a 12.1-in. version with
touchscreen, you must additionally remove the LED board from the
existing assembly. The LED board is attached to the upper left
corner of the front bezel assembly with 2 screws.
4. If you are replacing the bezel overlay on a 12.1-in. version with
touchscreen, attach the existing LED board to the new front bezel
assembly using the 2 screws. Tighten the screws to 4 - 6 in–lbs (0.5 -
0.6 N•m).
5. Place the metal frame in the new plastic overlay assembly and thread
any cables through the frame as required.
Replacing the Front Bezel
Plastic Overlay