Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 40)

4–2 Adding/Removing Internal Components
Publication 6182-UM001D-EN-P
The RAC6182 Industrial Computer accommodates one PCI compatible
add-in card. Due to thermal considerations with the unit, total add-in
power is limited to 7W of power dissipation (within the product
enclosure).
Table J
PCI Card Current Limits
Voltage Current Limit at Specified Voltage
5V 1.0A
3.3V 0.1A
12V 0.1A
-12V -0.05A
This section shows how to open and close the RAC6182 chassis to
access internal components.
ATTENTION: Review safety precautions on Page 4-1
before proceeding. Failure to follow proper safety
procedures could result in severe electrical shock or
damage to the RAC6182 Industrial Computer.
To open the chassis (display versions):
1. Disconnect power from the RAC6182 Industrial Computer.
2. Remove the 3 screws securing the chassis to the front bezel.
3. Open the chassis away from the front bezel. Be careful not to stress
or disconnect the internal cables running between the chassis and
front bezel.
Thermal Considerations
for Add-In Cards
Opening or Removing the
Chassis