Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 43)

Adding/Removing Internal Components 4–5
Publication 6182-UM001D-EN-P
To install a PC card:
1. Locate the PC card slots on the side of the RAC6182.
2. Loosen the screw on the PC card retainer bracket covering the PC
card slot, if necessary.
3. Insert the PC card into the desired slot. Make sure the PC card is
fully seated and the slot ejector is out. Up to 2 Type II cards can be
installed in the RAC6182.
Note: Most PC cards are hot-swappable on the RAC6182.
You do not need to turn off power to the unit. Install
one PC card at a time to ensure correct installation.
4. Position the PC card retainer over the PC card and slot ejector and
tighten the screw. Tighten the screw to a torque of 6 - 8 in–lbs (0.7 -
0.9 N•m).
5. Load the associated software and drivers for the card, if needed. The
Windows CE operating system automatically recognizes compatible
memory cards.
6. Follow instructions in the associated PC card user manual to make
any required external cable connections.
To remove a PC card:
1. Locate the PC card slots on the side of the RAC6182.
Note: Most PC cards are hot-swappable on the RAC6182.
You do not need to turn off power to remove the card.
Remove one PC card at a time to ensure correct
removal.
2. Loosen the screw on the PC card retainer bracket and rotate the
bracket to remove the PC card.
3. Remove any external cables attached to the PC card.
4. Press the slot ejector to unseat the PC card from the slot. Remove
the PC card and store in an anti-static wrapper.
5. Position the PC card retainer over any remaining PC card and slot
ejector and tighten the screw. Tighten the screw to a torque of 6 - 8
in–lbs (0.7 - 0.9 N•m).