Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System User Manual
Page 26
2–6 Installation
Publication 6182-UM001D-EN-P
4. Install the mounting clips. The mounting clips slide into the slots on
the top and bottom of the RAC6182 Industrial Computer.
5. Gradually tighten the clips one at a time around the bezel using the
specified sequence. Repeat this process at least three times until the
clips are hand-tight and the gasket is compressed uniformly against
the panel.
6. Tighten mounting clips to a torque of 10 in–lbs (1.1 N•m) in the
sequence shown above. Do not over–tighten.
ATTENTION: Tighten mounting clips to a torque of
10 in–lbs (1.1 N•m) to provide a proper seal and prevent
damage to the RAC6182 Industrial Computer. Allen–
Bradley assumes no responsibility for water or chemical
damage to the terminal or other equipment within the
enclosure because of improper installation.