Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 46)

4–8 Adding/Removing Internal Components
Publication 6182-UM001D-EN-P
5. Hold the board at each end and carefully rock the board back and
forth until the edge connectors pull free.
6. Store the board in an anti-static wrapper.
7. Install and secure a slot cover over the open slot. Tighten the screw
to a torque of 6 - 8 in–lbs (0.7 - 0.9 N•m).
8. Reinstall the screws to secure the top cover to the chassis. Tighten
the screws to a torque of 6 - 8 in–lbs (0.7 - 0.9 N•m).
The RAC6182 processor board contains one standard DIMM socket.
The DIMM memory can be upgraded or replaced.
The following DIMM modules can be ordered from Rockwell
Automation:
Part Number Description
6189-DIMM64 64MB SDRAM DIMM
6189-DIMM128 128MB SDRAM DIMM
6189-1DIMM256 256MB SDRAM DIMM
ATTENTION: DIMM memory modules are sensitive to
ESD and require careful handling. Hold memory
modules only by the edges--do not touch connectors.
After removing a module, place it into an anti-static
wrapper. Do not slide the module over any surface.
To access the DIMM socket:
1. Turn off power to the RAC6182.
2. Remove the 2 screws securing the top cover to the chassis.
3. Locate the DIMM socket on the processor board.
Adding/Removing RAM
Memory