Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 41)

Adding/Removing Internal Components 4–3
Publication 6182-UM001D-EN-P
To remove the chassis (display versions):
1. To remove the chassis completely from the front bezel, carefully
disconnect the internal cables from the chassis printed circuit board.
2. Remove the set-screw in the hinge, and lift the back chassis off the
front bezel hinges.
To replace the chassis (display version):
1. To replace the chassis, remount the chassis onto the front bezel
hinges and reinstall the hinge set-screw. Reconnect the cables to the
chassis printed circuit board.
2. To close the chassis, slowly hinge the chassis back against the front
bezel. Be careful not to pinch the internal cables.
3. Reinstall the 3 screws to secure the chassis to the front bezel. Tighten
the screws to a torque of 6 - 8 in–lbs (0.7 - 0.9 N•m).
Important: For a replacement chassis assembly, order the RAC6182
non-display unit with the required options (6182-xAxxxx).