Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 45)

Adding/Removing Internal Components 4–7
Publication 6182-UM001D-EN-P
4. Hold the card by the edges and firmly press the card into the PCI
connector.
5. Align the notch in the board retainer with the threaded hole on the
chassis and install the screw. Hold the notch tightly against the
screw before tightening. Tighten the screw to a torque of 6 - 8 in–lbs
(0.7 - 0.9 N•m).
6. Check any connectors on the PCI card to make sure they are
centered in the chassis opening.
7. Reinstall the screws to secure the top cover to the chassis. Tighten
the screws to 6 - 8 in–lbs (0.7 - 0.9 N•m).
8. Follow the PCI card user manual instructions when attaching any
required external cables to the card.
ATTENTION: Some 1784 communication cards have a
connector like the one used for the RAC6182 power
connector. Do not plug power into connectors on these
cards.
To remove a PCI card:
1. Disconnect power from the RAC6182 computer.
2. Remove the 2 screws securing the top cover to the chassis.
3. Remove any external cables attached to the PCI card.
4. Remove the screw securing the board retainer.