Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 42)

4–4 Adding/Removing Internal Components
Publication 6182-UM001D-EN-P
To open the chassis (non-display versions):
1. Disconnect power from the RAC6182 Industrial Computer.
2. Remove the 4 nuts securing the chassis to the front plate.
3. To close the chassis, reinstall the 4 nuts to secure the chassis to the
front plate. Tighten the nuts to 6 - 8 in–lbs (0.7 - 0.9 N•m).
One Type III PC card or two Type II PC cards (PCMCIA) may be
installed in the RAC6182 computer. While the RAC6182 PCMCIA slots
are electrically compatible with any standard PC card, special Windows
CE drivers are required to make the PC card function on the RAC6182
computer. Refer to the application program to make sure it supports the
desired PC card.
The following memory PC cards can be ordered from Rockwell
Automation:
Part Number Description
6189-ATA32 32MB ATA flash PC card
6189-ATA64 64MB ATA flash PC card
ATTENTION: Review safety precautions on Page 4-1
before proceeding.
Failure to follow proper safety procedures could result in
severe electrical shock or damage to the RAC6182
Industrial Computer.
ATTENTION: PC cards may be sensitive to ESD and
require careful handling. Hold cards only by the edges
do
not touch connectors. After removing a card, place the
PC card in an anti-static wrapper.
Adding/Removing PC
Cards (PCMCIA)