Rockwell Automation 2705 RediPanel Push Button Module - Manual (Page 15)

Chapter 2
Configuring the RediPANEL Module
2–3
The RediPANEL module has two DIP Switch banks.
Switch Bank Function
Switch Bank 1 (SW-1) Sets rack address.
Switch Bank 2 (SW-2) Controls baud rate, flashing lamps, fault mode
behavior, handshaking and last states.
The DIP Switch banks are located on the back of the RediPANEL module.
You can access the DIP switches by opening the back panel, as shown below.
DIP Switches
800T/H Module 800A Push Button Module
DIP Switches
800EM/EP Module
(Steel enclosure mounting shown.
Other styles similar)
DIP Switches
The following figure shows ON/OFF positions of the rocker style switches.
ON
OFF
FRONT SIDE
ON
ON
OFF
FRONT SIDE
OFF
ON and OFF switch settings are indicated by shading.
!
ATTENTION: Remove power from the module before setting
switches. Switch settings are scanned only on power-up.
The new settings take effect when you power-up the module.
DIP Switches