Rockwell Automation 2705 RediPanel Push Button Module - Manual (Page 29)

Chapter 3
Wiring and Installation
3–6
Fiberglass Enclosure Mounting Clearance Requirements
The enclosure mounting style requires a 2 inch (50 mm) clearance on the
latched side for opening and closing the enclosure cover. Adequate clearance
must be provided to allow for a minimum 90
_ swing of the cover.
4.00
(101.6)
Clearance for latches and opening of adjacent door.
Additional clearance may be required depending on
wiring configuration.
Clearance for Cover Swing
16 Button Module 13.5 (342.9)
32 Button Module 15.5 (393.7)
Wiring Cutouts (typical)
4.00
(101.6)
NOTE: If the wiring is run through the
bottom of the enclosure, it must be
secured to the tie wrap holders (provided).
The power wiring and the communications
wiring must be run through separate cutouts.
Steel Enclosure Mounting Clearance Requirements
The mounting style requires a 3 inch (76 mm) clearance on the latched side
for opening and closing the enclosure cover. Adequate clearance must be
provided to allow for a minimum 90
_ swing of the cover.
3.00
(76.2)
Clearance for Cover Swing
16 Button Module 13.5 (342.9)
32 Button Module 15.5 (393.7)
Clearance for latches and opening of adjacent door.
Additional clearance may be required depending on
wiring configuration.
Wiring Cutouts (typical)
NOTE: If the wiring is run through the
bottom of the enclosure, it must be
secured to the tie wrap holders (provided).
The power wiring and the communications
wiring must be run through separate cutouts.