Rockwell Automation 2705 RediPanel Push Button Module - Manual (Page 81)

Appendix B
Custom RediPANEL Modules
B–2
The Bulletin 800E selector switches described below can be installed in
RediPANELs:
Two Position Illuminated
These devices operate the same as a normal pushbutton. All wiring cable
terminals are used.
Two Position Non-Illuminated
The switch terminals wires (blue and grey) make normal connections. The
lamp wires are not used and must be insulated to protect them from touching
any other conductive material. The wire terminal should be insulated with
heat shrink tubing or tape and secured to the cable assembly with a tie wrap.
Three Position Non-Illuminated
This assembly requires that one of the adjacent positions not contain a push
button but either be left blank or contain a pilot lamp. Two terminal blocks
(800E-4X10V) are required. The gray wire from the adjacent terminal block
must be moved to the second terminal block on the three position selector
switch assembly. It may be necessary to cut the tie wrap to allow the wires to
reach the terminal block. If the adjacent position is blank, the blue wire that
would have been used for the lamp must be moved to the second terminal
block connector. If the blue wire is not long enough, a wire jumper
(2705-E3) must be installed from the second contact block to the first contact
block terminal screw. If the adjacent position contains a pilot lamp, the
existing wires stay as is in the adjacent position. The lamp wires and adjacent
contact block wires not used must be insulated to protect them from touching
any other conductive material. The wire terminal should be insulated with
heat shrink tubing or tape and secured to the cable assembly with a tie wrap.
When the switch is actuated left, the normal input image table bit will be set.
When the switch is actuated right, the adjacent location that was used will be
set.
Three Position Illuminated
This assembly requires that one of the adjacent positions not contain a push
button but either be left blank or contain a pilot lamp. Two terminal blocks
(800E-4X10V) are required. The gray wire from the adjacent terminal block
must be moved to the second terminal block on the three position selector
switch assembly. It may be necessary to cut the tie wrap to allow the wires to
reach the terminal block. If the adjacent position is blank, the blue wire that
would have been used for the lamp must be moved to the second terminal
block connector. If the blue wire is not long enough, a wire jumper
Custom 800EM/EP
RediPANEL Modules