Rockwell Automation 2705 RediPanel Push Button Module - Manual (Page 18)

Chapter 2
Configuring the RediPANEL Module
2–6
Figure 2.3 shows the functions and settings for Switch Bank 2 (SW-2).
Table 2.B defines the DIP Switch functions.
Figure 2.3
DIP Switch Bank 2 (SW-2) Settings
ON
OFF
1
2
3
4
5
6
7
8
ON OFF Example
1
2
3
4
5
6
7
8
ON OFF
SW-2
Switch Description Switch Setting
OFF
ON
1 Baud Rate 115.2K 57.6K
2 Steady Lamps Disabled Enabled
3 Flashing Lamps Disabled Enabled
4 Switch Fault Continue Halt
5 Last Chassis Last Not Last
6 Rack Size Full Table
7 Handshake Disabled Enabled
8 Last State Disabled Enabled
Baud Rate
Steady Lamps ENABLED
Flashing Lamps ENABLED
Switch Fault
Last Chassis
Rack Size
Handshake ENABLED
Last State ENABLED
Baud Rate (57.6K)
Steady Lamps (ENABLED)
Flashing Lamps (DISABLED)
Switch Fault (HALT)
Last Chassis (NOT LAST)
Rack Size (TABLE)
Handshake (DISABLED)
Last State (DISABLED)
ON
OFF
1
2
3
4
5
6
7
8
ON OFF Example
SW-2
1
2
3
4
5
6
7
8
ON OFF
SW-2
Switch Description Switch Setting
1 & 2 Baud Rate 57.K 1=ON 2=ON
115.2K 1=OFF 2=ON
230.4K 1=ON
2=OFF
N/A 1=OFF 2=OFF
3 Flashing Lamps OFF=Disabled ON=Enabled
4 Switch Fault OFF=Continue ON=Halt
5 Last Chassis OFF=Last ON=Not Last
6 Rack Size OFF=Full ON=Table
7 Handshake OFF=Disabled ON=Enabled
8 Last State OFF=Disabled ON=Enabled
Baud Rate
Baud Rate
Flashing Lamps ENABLED
Switch Fault Mode
Last Rack
Rack Size
Handshake ENABLED
Last State ENABLED
Baud Rate
Flashing Lamps (DISABLED)
Switch Fault (HALT)
Last Chassis (NOT LAST)
Rack Size (TABLE)
Handshake (DISABLED)
Last State (DISABLED)
SW–2
RediPANEL 800A and 800EP/EM Membrane Modules
RediPANEL 800T/H Modules
Baud Rate
(57.6K)
Setting Switch Bank 2